CM30 Solar Charge Controller

CM series controller is a kind of intelligent, multi-purpose solar charge and discharge controller.

 

Specifications

1). 30A 12/24V Regulator 2). increase 30% charging efficiency 3).CE RoHS approved 4).temperature sensor outside 5. JUTA

1. Product Introduction

CM series controller is a kind of intelligent, multi-purpose solar charge and discharge controller. The family use the fixed LCD display, with a very friendly interface; various control parameters can be flexibly set, fully meet your various application requirements. CM series controller has following features: 

Image of LCD graphic symbol                 Simple button operation

Automatic Identification System Voltage level

Intelligent PWM charge mode

Automatic Temperature Compensation

Adjustable charge-discharge control parameters

Settable Operating mode of Load

Accumulated function of charge and discharge Ampere hours

Remote monitoring and control function (custom)

Battery reverse-discharge protection

Battery Low Voltage Disconnection (LVD)

Battery reverse connection protection            Overload, Short Circuit Protection

 2. Installation

Install

       Ready tools and cables. Encourage you to matching the right cables. Ensure that the current density 4mm²  that is conductive to reducing the line voltage drop. Recommended: 30A with 10mm² cable. Check weather the installation sites compliance with the relevant safety requirements. Please avoid the damp, dusty, there is a place flammable, explosive and corrosive gases use the controller to install.    

       Install the controller into a fixed vertical plane. See section 5 of the pore size and pore spacing. In order to ensure a good thermal control conditions, please set aside each 10cm below the controller space.

       As shown on the right, connect the (1) Load, (2) Battery and (3) Solar Panel to the controller according to the order of (1) (2) (3). Pay attention to the load, battery, solar panel and controller of same polarity.

       Put into the external temperature sensor on the left of the controller (probe port). The temperature sensor should be similar space with battery. (Otherwise, the controller will control the parameters of all wrong temperature compensation.)

       If you have remote monitoring and control function, please insert one end of the included communication wire on the right of the controller (communication port), the other end to connect to the host computer.

Demolition To prevent accidents, please order the demolition of solar panels, battery and load disconnect with controller.

Note Battery polarity will not damage the controller, but you will have a load equipment security risks.

 5. Technical Data             

 

Data            Model	CM2024Z	CM3024Z	CM2048	CM3048	Data           Model	CM3024Z	CM3048
Rated Current	20A	30A	20A	30A	Installation cable area.	≤7#  AWG  (16mm2)
Rated Voltage	12V/24V		48V		Operating Temperature	-10°C~60°C
Open Circuit Voltage of solar panel	≤50V		≤100V		Storage temperature	-30°C~70°C
Float Voltage	13.8V/27.6V		55.2V		Humidity requirements	≤90%,no condensation
Low Voltage Disconnection(LVD)	10.7V/21.4V		42.8V		Size	90 mm×188 mm×48 mm
Low Voltage Reconnection(LVR)	12.5V/25.0V		50.0V		Mounting hole spacing	60 mm×178 mm --Φ5
No load loss	≤30mA		≤		weight	360g
Loop Voltage Drop	≤170mV		≤
Charging Mode	PWM mode
Temperature Compensation	-4mV/Cell/°C
Notes	Model suffix “Z” represent automatic identify system voltage level,“T” represent controller with remote monitoring.

CM30 Solar Charge Controller